Assembly
08.00 | PZN-plus | Assembly and Operating Manual | en | 0389374
37
Ø
Tighten the screw (3) on the bracket (2).
Tightening torque: 0.2 Nm
Ø
Adjust sensor (1), see Translation of Sensor Assembly and Oper-
ating Manual.
Variant Dust-tight:
Screw in set-screw into the side cover.
5.3.13 Mounting the analog position sensor APS-Z80
To be able to mount the sensor, the gripper has to be retrofitted
with a special mounting kit.
NOTICE
Blockade of the gripper after setting or replacing of the switch-
ing cam!
The switching cam can be tilt in the guide, if it was not fixed ex-
actly in the base jaw.
•
Apply the switching cam in the direction of the base jaw, so
that the cam does not contact the housing of the gripper.
Variant Dust-tight:
Before attaching the sensor, remove the sealing bolts from the
bracket. Before adjusting the control cam, unscrew the set-screw
from the side cover.
Ø
Move product to the "gripper open" position.
Ø
Loosen screw (4) and remove control cam (6) for the inductive
monitoring from the base jaw.
Ø
Remove screw (5) from the base jaw.
