Assembly
38
08.00 | PZN-plus | Assembly and Operating Manual | en | 0389374
Ø
Apply adhesive to the top and sides of the control cam (6) from
the mounting kit.
✓
Make sure that there is no adhesive on the bottom of the
control cam (6), which comes into contact with the sensor.
✓
SCHUNK recommends the adhesive Loctite 290 or 638.
Ø
Slide control cam (6) into the base jaw to the stop.
✓
Ensure that the higher front side of the control cam (6) is
pointing outwards.
Ø
NOTICE! The control cam (6) must no longer move after it is
screwed on.
Screw the control cam (6) to the base jaw using the screw (5).
✓
Secure the screw (5) with medium-strength locking liquid.
Ø
Slide the sensor (1) to the stop into the bracket (2).
Ø
Tighten the screw (3) on the bracket (2).
Tightening torque: 0.2 Nm
Ø
Adjust sensor (1), see Translation of Sensor Assembly and Oper-
ating Manual.
Variant Dust-tight:
Screw in set-screw into the side cover.
5.3.14 Mounting the radio system RSS-R1/T2
The radio system RSS-R1/T2 can be used with the following
sensors:
• Reed switch RMS 80
Assembly
Ø
Install the sensor,
Mounting the reed switch RMS 80
[
}
30].
Ø
Adjust the sensor, see the Assembly and Operating Manual for
the sensor.
Ø
Connect the radio system, see the Assembly and Operating
Manual for the radio system.