Assembly
48
06.00 | NSR-A | Assembly and Operating Manual | en | 389722
5.6 Tolerances and installation conditions for clamping pins in
customer-specific pallet adapters
CAUTION
Material damage caused by installing incorrectly dimensioned
components!
The holding force of the pallet changing system is essentially
limited by the tightness of the screw connection which connects
the clamping pin to the pallet adapter. Installing the clamping pin
with the incorrect components, e.g. mounting screws that are
too short can lead to significant material damage.
•
Only original SCHUNK clamping pins may be used. These are
available from SCHUNK as a spare part.
•
Install the clamping pin with a screw of strength class 12.9. It is
imperative that the tightening torque is strictly adhered to.
•
If the clamping pin is to be used in customer-specific pallet
adapters, the customer must provide a sufficiently
dimensioned depth of engagement in the clamping pin or a
sufficiently thick mounting material in the adapter strip.
•
The installation dimensions are based on different adapter
strip materials for the customer-specific pallet adapter and
must be observed.
Check the screw fitting of the clamping pin at regular intervals to
ensure that it is secure.
Note
Only the complete pallet adapter coupling can be replaced in the
pallet coupling change interface. Replacing only the clamping pin
would mean that the required complete flat work surface would
not be achieved at the change interface.