Maintenance
60
28.00 | DPG-plus | Assembly and Operating Manual | en | 389031
Assembly
Ø
Insert the base jaw (2/7) into the intermediate jaw (13) and
tighten the screw (43).
Ø
Push the base jaw (2/7) into the housing (1), observing the
correct installation position.
Ø
Position the base jaws (2/7) so that the piston (3/8) can be
pushed into the base jaws (2/7) without any problems.
Ø
Insert the piston (3/8) into the housing (1) from above.
Ø
Insert the seal (31) into the housing (1) from above.
Ø
Previous version:
Slide the cylinder piston (60) from below into
the housing (1), observing the correct installation position.
Ensure that the sealing lips of the seal (30) do not become
damaged while sliding in the cylinder piston.
Successor version:
Slide the cylinder piston (71) into the
housing (1) from below. When doing this, observe the correct
installation position. Ensure that the sealing lips of the seal (30)
do not become damaged while sliding in the cylinder piston.
Ø
Install the intermediate piston (66).
Ø
Assemble a second cylinder piston (6/10) on the intermediate
piston with the screw (40/45). Ensure that the sealing lips of the
seal (30) do not become damaged while sliding in the second
cylinder piston.
Ø
Insert seals (32/38) and (34) in the intermediate housing (65).
Ø
Slide the intermediate housing (65) over the cylinder
piston (6/10).
Ø
Fasten the cover (4) with the screws (46).
Ø
Previous version:
Insert the gasket (14) into the housing (1).
Note: The product must be in the "Gripper closed" position to
prevent the gasket (14) / the O-ring (39) from jamming.
Successor version:
Insert the flat seal ring (39) into the side
cover.
Ø
Put on the side cover (12), making sure the installation position
is correct.
NOTE
Do not damage the sealing lips of the seal (36) with the
intermediate jaw (13).
