Maintenance
28.00 | DPG-plus | Assembly and Operating Manual | en | 389031
55
Final assembly
Ø
Insert seals (34) / (32/38) into the cover (9).
Ø
Insert the centering sleeves (19) into the housing (1) and fasten
the cover (9) to the housing (1) with screws (46).
Ø
Previous version:
Insert the gasket (14) into the housing (1).
Note: The product must be in the "Gripper closed" position, to
prevent the gasket (14) from jamming.
Successor version:
Insert the flat seal ring (39) into the side
cover (12).
Ø
Put on the side cover (12), making sure the installation position
is correct.
NOTE
Do not damage the sealing lips of the seal (36) with the
intermediate jaw (13).
Ø
Do not screw the screw (42) completely into the cover (12). The
gap between the side cover (12) and the housing (1) should be
approximately divided in half.
Ø
Allow the product to run approx. 20 cycles in order to center
the side cover (12).
Ø
Tighten the screws (42) to fasten the side cover (12).
Ø
Only for previous version:
Apply a strip of Plast-o-Seal along
the side cover (12),
Position of the Plast-o-Seal (previous version)
62].
Ø
Previous version:
Insert the seal (37/20) into the housing (1).
Successor version:
Insert the flat seal (20) into the housing (1).
Ø
Screw the cover plate (5) on tight with the screws (47).
