Setup
7
Electrical connection
7.2
Table saw BS-350 LST, BS-400 LST-E230, BS-400 LST-E400, BS-500 LST
41
/80
10) Adjust the cutting depth by turning the cutting head and tighten the
clamp screw.
11) Fill up the tub with water.
12) Connect the machine to the power supply system and switch it on,
regulate water supply by using the water tap.
13) Solve the clamp screw, which secure the cutting head.
7.2
Electrical connection
Danger
Danger of injury due to electrical voltage!
There is a risk of injury when touching live parts.
−
All electrical connection work may only be performed and inspected
and approved by trained electricians.
−
Live cables must not come into contact with water or water mist.
The electrical connection of the machine may only be made via a suitable
power distribution board. Portable machines used outdoors must be con-
nected through a fault-current circuit breaker.
The Table saw BS-350 LST, BS-400 LST-E230, BS-400 LST-E400, BS-500
LST are subject to increased safety requirements for wet operation.
Make sure that the machine is always grounded.
Do not use any adapters on the machine. Only use extension cords that
meet the requirements of the Table saw BS-350 LST, BS-400 LST-E230,
BS-400 LST-E400, BS-500 LST and the installation site (cross-section, insu-
lation, etc.).
1.
Check whether the mains voltage matches with the machine data (see
section.
2.
Check whether a correctly laid ground cable is available.
3.
Connect the Table saw BS-350 LST, BS-400 LST-E230, BS-400 LST-
E400, BS-500 LST to the mains according to the prescribed electrical
specifications via the socket for the mains connection.
