7
Setup
6.5
Handling packaging materials
40
/80
Table saw BS-350 LST, BS-400 LST-E230, BS-400 LST-E400, BS-500 LST
7
Setup
Any installation work may only be carried out by trained personnel author-
ized by the operator. For all installation work the necessary personal protec-
tive equipment (workwear, safety shoes) must be worn.
Work on the electrical connection may only be carried out by qualified elec-
tricians.
Notes on setup
Caution
Danger of tripping due to faulty routing of the energy supply!
The cables laid on the floor pose a risk of tripping and therefore falling.
−
When setting up the machine, make sure that the energy supply is
covered or marked accordingly.
−
If possible, move the energy supply in such a way that it poses no
danger to transport traffic and people.
−
The surface on which work takes place must: have sufficient load-
bearing capacity, be non-slip, be horizontal and even or not exceed an
inclination of 5 %.
Instruction for use
1) Solve the machine feet from the transport lock and fold them out. Insert
each of them in their designed seating (slot) at the corners of the frame
until it stops and then tighten the thumb-screws.
2) Take care that the machine stands on solid ground when cutting. Balance
out uneven surface.
3) Attach the spring holder (Pos. 31, see exploded view) on the side (Pos.
27) and hang up the cable and water hose in the eyelet of the spring
holder.
4) Tighten the clamping screw for securing the cutting head.
5) Solve the clamping screw on the blade guard box and bring the cutting
head for clamping the blade in the uppermost position.
6) Remove the outer flange after loosening the hexagonal nut.
7) Fix the suitable diamond blade at the corresponding seat (Ø 25.4 mm) at
the inner flange.
8) Pay attention on the correct mounting of the diamond blade:
a) The rotation direction of the blade (pay attention on the engraved arrow
at the blade) and the shaft must be corresponding.
b) Bore of the blade (25.4 mm) and retainer at the flange must be corre-
sponding.
c) The inner side of the flange must be free of dirt every time, to ensure a
plain seat of the blade.
9) Replace the outer flange, tighten the flange nut, place blade protection
cover/ guard and secure with the clamp screw.
