Schmalz Jumbo Ergo, Operating Instructions Manual, Page: 36 / 57

INSTALLATION
36 | EN www.schmalz.com 30.30.01.00173/04
5.6.2 With load
Procedure:
Rotate the adjusting screw (2) on the Sprint operator handle (can be
accessed from above).

Rotate clockwise

hovering position is lowered.

Rotate counterclockwise

hovering position is raised.
5.7 Test
It is not possible to preset the hovering position with load for the vacuum tube lifter
Jumbo Ergo. The hovering position with load can only be adjusted using the control
handle.
Blower damage
If the hovering position with load is set to the highest level (end-stop
position), the blower will overheat and become damaged.
This setting also results in an increased energy consumption.
►
Do not set the hovering position with load to the highest level (end-stop
position).
ATTENTION
Installation of the vacuum tube lifter Jumbo is complete following 3-4 successful test
runs using a workpiece. The checks required in Europe before initial use in
accordance with EN 14238 are covered by a type test.
To set the hovering position of the vacuum tube lifter J
UMBO
S
PRINT
with load (caution, not to be confused with the hovering position with
load), adjust the adjusting screw (2).