Schindelhauer Bikes Arthur, Manual

Page: 83 / 132

83
EN
When twisting the handlebar to the transport position take care that the
cables and housings are not cut or bent sharply. Proceed as follows:
1. Loosen the stem clamping bolt on the right side of the stem (6mm
hex key)
2. Carefully twist the handlebar 90° clockwise.
3. Tighten the stem clamping bolt. For transport without a rider it is suf-
ficient to tighten the bolt to an extent that the handlebar won’t twist
during transport.
Remove the pedals with a 6 mm hex key. Note that the left pedal has a
left-hand thread! When installing the pedals again, follow the instructions
in chapter 3.3 on page 57.
9.2 Twist the handlebar for transport
9.3 Removing the pedals
Caution! To make the e-bike ready for riding after transport
is comlete, it’s essential to follow the instructions in
chapter 3.2 on page 56.
The stem clamping bolt MUST be tightened with the
correct torque of
14-15 Nm! Danger of accident!!
Description Thread Torque Tool
Through axle FW* M14x1,5 10 Nm 6mm hex key
Hub bolts RW* M12 35 Nm
8 mm hex key or
17 mm open-end
wrench
Stem / steerer clamp*
M8 15 Nm 6 mm hex key
Stem / handlebar clamp* M5 5-6 Nm 4 mm hex key
A-Head cap (adjusting screw) M6
1-2 Nm
(according
to bearing
clearance)
5 mm hex key
Brake calliper M6 9 Nm 5 mm hex key
Brake lever (handlebar) M5 3 Nm 4 mm hex key
Seat clamp (saddle)* M6 12 Nm 5 mm hex key
Seat clamp (frame)* M6 8 Nm 5 mm hex key
Front sprocket (crank) M8x0,75 15 Nm 5 mm hex key
Rear sprocket (freewheel
lockring) *
- 40 Nm
Shimano cassette
removal tool
Pedals* 9/16“ 35 Nm 6 mm hex key
Dropout sledge bolts M8 15 Nm Torx 40
Frame key bolt M6 10 Nm 5 mm hex key
Bottom bracket plate M3 2-3 Nm Torx 10
Kickstand adapter plate M6 10 Nm 5 mm hex key
Cable mount (left chain stay) M5 5 Nm Torx 25
Inner Grip Screw M4 2 Nm 3 mm hex key
Outer Grip Screw M5 5 Nm 4 mm hex key
* always apply assembly paste to connecting surfaces
10. Tightening torques