9
LAWNAIRE ZTS
LABELS
BELT ROUTINGS
ENGINE
PULLEY
4172916
USE SAME HOLE ON BOTH SIDES
1
2
3
4
5
6
7
PIN MAX DEPTH
1
2”
2
2-1/2”
3
3”
4
3-1/2”
5
4”
6
4-1/2”
7
5”
4172886
USE SAME HOLE ON BOTH SIDES
1
2
3
4
5
6
7
1
2”
2
2-1/2”
3
3”
4
3-1/2”
5
4”
6
4-1/2”
7
5”
4172887
PIN MAX DEPTH
CALIFORNIA SPARK ARRESTOR WARNING
Operation of this equipment may create sparks that can start fires around dry
vegetation. A spark arrestor may be required. The operator should contact
local fire agencies for laws or regulations relating to fire prevention requirements.
4172911
-Wet grass or steep slopes can cause sliding and loss of control.
-Wheels dropping over edges can cause rollovers.
-Going up or backing down steep slopes or ramps can result in
backward rollovers.
To reduce potential for possible loss of control and rollover
resulting in serious injury or death:
-Stay off slopes machine cannot back up with tines raised.
-Do not operate near drop offs or water.
-Do not operate without tires on ground.
-Do not use split ramps; use full width ramps to load unit.
-Reduce speed and use extreme caution on slopes and ramps.
-Avoid sudden turns and rapid speed changes.
WARNING
green is white border.
Read and understand the Operator Manual before servicing.
Every 50 hours or weekly
Yearly
- Check hydraulic level
Grease:
- Check tire pressure
Caster pivots
- 15 psi rear
Transaxle pivot
- 25 psi front
Hydraulic cylinder pivot
- Check chain tension
- Lubricate chain
Fill with 20w50 motor
oil to level indicated
FULL COLD
HYDRAULIC OIL
WARNING
STORED ENERGY
- TINES MAY DROP SUDDENLY.
- SUPPORT LOWER TINES BEFORE
SERVICING HYDRAULIC SYSTEM.
- SEE OPERATOR MANUAL FOR
SERVICE PROCEDURE.
HIGH PRESSURE FLUID
Leaks can penetrate skin.
- Seek immediate medical attention
for oil penetration injury.
- See Operator Manual for proper
methods to service hydraulic
system and locate leaks.
WARNING
4172910
Service Guide
4172915
JACK STANDS
TO RAISE MACHINE:
With engine running
- Pull depth stop pins.
- Lower tines.
- Increase tine pressure to raise machine.
- Pin jack stands in raised position.
- Raise tines to set machine on stands.
TO LOWER MACHINE:
With engine running
- Lower tines.
- Increase tine pressure to raise machine.
- Pin jack stands in operating position.
- Raise tines to set machine on wheels.
- Reinstall depth stop pins.
- When jack stand has been positioned, run or stop engine as appropriate
for the work being performed.
- Do not work under machine with engine running.
- Tine may drop suddenly.
TEXT “ZTS” TO 77453 IN THE US AND
76000 IN CANADA FOR A VIDEO WITH
OPERATING INSTRUCTIONS.
4176056
