18
LAWNAIRE ZTS
TRANSPORTATION / STORAGE
TRANSPORTATION
OPERATOR PLATFORM
To reduce the space required, the operator platform
may be folded up. A latch is provided to hold it in the
"UP" position. the latch automatically engages when
the platform is raised. to lower the operator platform,
raise the latch to disengage it and lower the platform.
See Controls Section Pg. 13
LOADING THE MACHINE
DO NOT use split ramps when loading or unload-
ing the machine on a truck or trailer. Use full width
ramps rated for at least the machine weight ( Approx-
imately 1200 lbs (545 kg)) plus operator weight. Full
width ramps reduce the possibility of falling off the
ramp. Reduce engine speed and drive slowly when
loading or unloading the machine.
Secure the machine before transporting. Front
Q
and rear
R
tie down locations are provided to secure
the machine.
STORAGE
To prevent possible explosion or ignition of vaporized
fuel, do not store equipment with fuel in tank or
carburetor in an enclosure with an open flame (for
example, a furnace or water heater pilot light).
Before the equipment is put into storage for any
period exceeding 30 days, the following steps
should be taken.
1. Drain all fuel from the fuel tank and fuel lines.
2. Start the engine and run until all the fuel is used
from the carburetor float bowl.
3. While the engine is still warm, drain the
crankcase oil and refill with the proper weight oil
corresponding to the season the equipment will
next be used.
4. Remove the spark plug and squirt a small
amount of engine oil into the cylinder. Turn the
engine over a few times to distribute the oil.
5. Lubricate the chains.
To put the equipment into service after an
extended period of storage:
1. Check for loose parts and tighten if necessary.
2. Check for cracked or broken tines and replace
as necessary.
3. Fill the fuel tank with clean, fresh fuel.
4. Check the engine and gear reduction case oil
levels with the engine in a level position.
5. Start the engine.
6. Check for fuel leaks.
7. Check operator present operation.
