Scheppach 5905208901, Translation From The Original Instruction Manual, Page: 19 / 140

19 | GB
1. Introduction
MANUFACTURER:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
DEAR CUSTOMER,
We hope your new tool brings you much enjoyment
and success.
NOTE:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by
the product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non-original spare
parts,
• Application other than specified,
• A breakdown of the electrical system that occurs
due to the non-compliance of the electric regu
-
lations and VDE regulations 0100, DIN 57113 /
VDE0113.
m
Important! We recommend:
Read through the complete text in the operating in -
structions before installing and commissioning the
device. The operating instructions are intended to
help the user to become familiar with the machine
and take advantage of its application possibilities in
accordance with the recommendations. The operat
-
ing instructions contain important information on how
to operate the machine safely, professionally and
economically, how to avoid danger, costly repairs, re
-
duce downtimes and how to increase reliability and
service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula
-
tions that apply for the operation of the machine in
your country. Keep the operating instructions pack
-
age with the machine at all times and store it in a
plastic cover to protect it from dirt and moisture.
Read the instruction manual each time before op
-
erating the machine and carefully follow its informa -
tion. The machine can only be operated by persons
who were instructed concerning the operation of the
machine and who are informed about the associated
dangers. The minimum age requirement must be
complied with.
We assume no liability for accidents or damages
resulting by disregarding these instructions and the
safety instructions.
2. Layout (Fig. 1)
1. Oil Tank
2. Log Pusher
3.
Work Table
4. Wedge
5.
Lift Handle
6. Support Leg
7. Switch
8. Motor
9. Transport Wheel
10. Hydraulic Lever
11. Oil Drain Bolt w/ dipstick
12. Venting screw
13. hoist limiting ring
3. Scope of delivery
• Open the packaging and remove the device care -
fully.
• Remove the packaging material as well as the
packaging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for trans -
port damage.
• If possible, store the packaging until the warranty
period has expired.
ATTENTION
The device and packaging materials are not toys!
Children must not be allowed to play with plas-
tic bags, film and small parts! There is a risk of
swallowing and suffocation!
Hydraulic Log Splitter
Operation Manual
4. Intended use
The wood splitter has only been designed to split
wood in the fibre direction. Respecting technical data
and safety precautions. The machine meets the cur
-
rently valid EU machine directive.
The hydraulic log splitter is designed only for wood
in a horizontal position. Wood may only be split while
horizontal and in the direction of the grain.
Log dimensions are:
Log lengths max. 52 cm
Ø min. 5 cm, max. 32 cm
Never split wood against the grain or while in an
upright position!
1. The equipment is to be used only for its pre -
scribed purpose. Any other use is deemed to be
a case of misuse.
2. The user / operator and not the manufacturer will
be liable for any damage or injuries of any kind
caused as a result of this.