5
– FUNCTIONING AND USE
COD.
60M12/24.D.2018
EN
THE PRESENT MANUAL BELONGS TO -
Schenker Italia
- ALL RIGHTS RESERVED
35
This message means that a hydraulic block of the machine occurred, and then the pump has been
switched off as safety procedure. In this case is suggested to perform a reset procedure and investigate
on the possible hydraulic origins of the problem.
If the origin of the problem is just a malfunctioning of the signal pressure switch, it is possible to start again
the unit, activating the bypass.
•
BYPASS WARNING
This message advices or remembers that the unit is working in bypass mode (then some safety functions
are disabled).
•
CHANGE PUMP FILTERS
This is a blinking message that must be acknowledged pressing the key STOP.
This message suggests to replace the filter of the pump group.
Display indications during production
During the normal functioning of the watermaker the display gives the following indications:
Pump 1 OFF/ON
Pump 2 OFF/ON
Messages related to the salinity meter (optional):
S = wait
This means that the salinity meter is still completing calculations.
S = OK
Quality of the produced water good
(
micro Siemens 0-1500)
S = MED
Quality of the produced water medium (micro Siemens 1500-2000)
S = BAD
Quality of the produced water bad (micro Siemens over 2000).
In this last case, please stop the watermaker and schedule a service.
TIME.
It is the time from the starting. If the timer function has been used the time will indicate the remaining
time to stop.
