Scarab M65T, Operating And Basic Maintenance Instructions

Page: 38 / 58

Scarab M65T Operating Instructions
Part No. SCAZ043468 1.6.01 38 E&OE
Suction Nozzle Clearances
Inspect the suction nozzle flaps to verify that they are in good condition
and do not show excessive wear. Adjust as necessary to achieve the
correct flap to ground clearances. The factory settings are:
• Inboard Side Flap = 15 mm
• Front Flap = 20 mm
• Rear Flap = 15 mm
These clearances are based on the factory setup. For some operating
conditions, it might be found that, alternative clearances are
preferred.
Side Brushes
Do not attempt to alter the brush settings while the brush is
rotating.
Before proceeding ensure that people and objects are clear of
the brush area.
An effective brush set-up ensures good sweeping performance. The
following settings produce excellent results in most conditions.
Experience will determine if other settings are better suited to specific
conditions.
1. Vehicle stopped, handbrake ON, sweep mode ON, activate the
desired brush(es) in their working positions.
2. Switch OFF ignition and remove the key.
3. Locate the appropriate valve(s) in the pneumatic cabinet and activate
the manual override
( 1 )
to allow the brush(es) to extend.
4. Adjust the top link ( 2 ) and/or the motor plate ( 3 ) until the brush is at
the correct contact with the road surface. See diagram ( 4 ) . Re-tighten
any items slackened during adjustment.
5.
Re-start vehicle, stow all sweeping equipment activated for
adjustment.
Tow point
Skid plate
(Shown ghosted)
Front flap
Rear flap
Adjust for parallel running
Inboard side flap
front flap
rear flap
2
3
1
4
315-320mm
Manual override
Fixing nuts
Brush pattern Motor centre
Motor centre