SCANMASKIN Scan Combiflex 450, Manual

Page: 63 / 190

63
ENGLISH
www.scanmaskin.com
SCAN COMBIFLEX 450/450NS
5.4 Grinding disc replacement / assembly
Follow these steps to replace the Scan-On plate

Make sure the machine is in its “Safety off position”

Tilt the machine backwards and secure it.

Remove any tools used according to”4.14 Changing tools”.

Loosen the three screws holding the Scan-On plate.

Replace the Scan-On plate.

It’s recommended that new screws are used to fasten the replacement Scan-On plate.

It’s also recommended that copper paste is used on the surface of the screw hole at the Scan-
On plate.

Tighten all screws by hand and make sure that they are secured.
5.5 Cleaning the machine
Before starting to clean the machine, make sure it is in its”Safety off position”
The power must not be connected while cleaning the machine.
Do not use highly pressurized water to clean the machine.
Water and soap is recommended.
5.6 Trouble shooting
5.6.1 Common faults
Symptom Cause Correction A
6
The machine
won’t start

There is a power failure from
the power supply

Inspect the fuses in the worksites
fuse box

Inspect cables

Measure that all three phases are
present and at full voltage near the
machine
O
E
E
The machine only
operates while
the start button is
depressed

The motor is overheated

Wait until the motor is cool again O

The control device is dam -
aged

Replace the control device S
6