innovators for industry
RTC
®
4 PC Interface Board
Rev. 1.3 e
107
List Command
set_jump_speed
Function
defines the jump speed for the following vector commands
Parameter
jump_speed
jump speed in
bits per ms
(64-bit IEEE floating point value)
Allowed range: [1 … 50000]
Integration
Pascal:
procedure set_jump_speed(jump_speed: double);
C:
void set_jump_speed(double jump_speed);
Basic:
sub set_jump_speed(ByVal jump_speed#)
Comments
• The command is written directly into the list.
• The specified jump speed is used for all subsequent jump commands until a new value
is specified.
• To obtain the actual jump speed
v
in the image plane (in
meters per second
), the
specified speed value (in
bits per ms
) must be divided by the calibration factor
K
of the correction file (in
bits per mm
):
v
jump
= jump_speed /
K
References
List Command
set_laser_delays
Function
sets the LaserOn delay and the LaserOff delay.
1 bit equals 1
µ
s.
Parameters
laser_on_delay
signed 16-bit value. Allowed range: [ – 8000 … +8000]
laser_off_delay
signed 16-bit value. Allowed range: [+2 … +8000]
Integration
Pascal:
procedure set_laser_delays(laser_on_delay, laser_off_delay:
smallint);
C:
void set_laser_delays(short laser_on_delay, short laser_off_delay);
Basic:
sub set_laser_delays(ByVal laser_on_delay%, ByVal laser_off_delay%)
Comments
• See the section
, for details.
• The LaserOff delay must always be longer than the LaserOn delay.
"Limits For The Delays" on page 24
• If the LaserOn delay is negative, the total marking time is extended.
References
