8
www.sawo.com | [email protected]
TECHNICAL GUIDE
STN Steam Generators
STN Control Panel Instructions of Use
There are four different operation modes in the unit: Off, On, Standby and Drain. The user can easily switch between different
modes, making the steam bathing more convenient with less energy consumption.
To use steam room the control unit needs to be in the On mode. In the On mode, the steamer is active, the temperature in
the steam room will be kept in the preferred, set temperature, with occasional discharge of steam.
However, if the steam room is not used constantly, the generator can be set to Standby mode. The water in the tank is kept
warm, with minimal energy usage. The generator is able to produce steam shortly after the unit is switch back to On mode
for the convenience of the users.
More details about the different modes and how to move between them can be found in the text and graph following.
On/Off Mode
When the power switch is turned “On” the software versions of the control board and the user interface will be displayed for 1
second each. Then the control unit will go to “Off” mode. In the “Off” mode, the display is blank.
The auto drain can be disabled or enabled in the “Off” mode. Press and hold the Up button, then press the Power button. The
display will show “Adr oFF” or “Adr on” as feedback.
On Mode
For “On” mode press “Power” button.
First, the set steam room temperature is displayed blinking for 5 seconds. Then the user can change the following settings;
session time, temperature and fan (not all the models have the same features), by pressing the corresponding button in the
control unit. The up and down arrow buttons can be used to increase and decrease the values.
If no buttons are pressed for 10 seconds, the set temperature for the steam room will be displayed.
When the session time expires, the control unit will go to the “Standby” mode.
Power
Down
Cabin lights/Dimmer
Fan/Scent pump
Up
Temp/Timer
Standby