Section 3: Configuration
Page 3-20
XL400/410e Operator’s Manual
Cut Position
When the printer is in the Cut mode (cutter enabled), the Cut Offset is set using the LCD Service
Mode to correctly position the label for cutting. Once the correct Cut Offset is obtained, it may be
necessary to adjust the position slightly.
This is done with the CUT POSITION potentiometer on the front panel. When turned all the way
clockwise the cut position is moved down the tag 3.75mm and when turned all the way
counterclockwise, the cut position is moved 3.75mm toward the top of the tag.
1. Turn the printer on.
2. Press the START/STOP key to place the printer in the OFF LINE status.
3. Press the FEED key to feed out a blank label.
4. Adjust the position using the Cut Position potentiometer on the Control panel and feed
another label by depressing the FEED key.
5. When the adjustment is correct, turn the printer off.
DEFAULT OFFSET SETTINGS, XL400E