Section 2: Installation
XL400/410e Operator’s Manual
Page 2-19
2.11 CUT SENSOR ADJUSTMENT (CONT’D)
The scale used depends upon the type of media selected (i.e. R-Corner, Center-
Hole or Side-Hole). The setting corresponds to the width of the media (i.e., if you
are using center hole tags that are 80mm wide, the notch should be set at the
80mm mark of the black scale).
NOTCH
R-CORNER
If you are using R-Corner Notch Tags, the tag notch must be on the inside edge of
the tag and the position the Sensor Select Switch should be towards the outside
of the printer. For all other tags, the Sensor Selector Switch should be towards the
inside of the printer.
OTHER TAG
SCALE
R-Corner: Inside scale, 32 to 42 mm.
Center-Hole: Black scale
Other Tag: 47 to 100 mm
R-Corner, 32 to 42 mm
Side Hole: Blue scale, 50 to 100 mm
See Tag Charts on pages 2-8 to 2-9
See Tag Charts on pages 2-8 to 2-9
if you are unsure about tag type.