SATO XL 410e, Operator'S Manual, Page: 37 / 80

Section 3: Configuration
XL400/410e Operator’s Manual Page 3-3
3.1 PRINTER DIP SWITCH CONFIGURATION (CONT’D)
Stop Bit Selection (DSW1-4): Selects the number of Stop bits to end each byte’s transmission.
Baud Rate Selection (DSW1-5, DSW1-6): Selects the data rate (bps) for the RS232 port.
Protocol Selection (DSW1-7, DSW1-8): Selects the flow control and status reporting protocols.
See Section
5 : Interface Specifications for more information..
Printer Set up
Print Mode Selection (DSW2-1): Selects between direct thermal printing on thermally sensitive
paper and thermal transfer printing using a ribbon.
Reserved (DSW2-2): Reserved for future use.
Head Check Selection (DSW2-3): When selected, this option causes the printer to check for
head elements that are electrically malfunctioning..
DSW1-4 Setting
Off 1 Stop Bit
On 2 Stop Bits
DSW1
ON
OFF
1 2 3 4 5 6 7 8
DSW1-5 DSW1-8 Setting
Off Off 9600
Off On 19200
On Off 4800
On On 2400
DSW1
ON
OFF
1 2 3 4 5 6 7 8
DSW1-5 DSW1-8 Setting
Off Off Ready/Busy
Off On X-On/X-Off
On Off Bi-Com
On On Not Used
DSW1
ON
OFF
1 2 3 4 5 6 7 8
DSW2-1 Setting
Off Thermal Xfer
On Direct Therm
DSW2
ON
OFF
1 2 3 4 5 6 7 8
DSW2-1 Setting
Off Disabled
On Enabled
DSW2
ON
OFF
1 2 3 4 5 6 7 8