Section 3: Configuration
XL400/410e Operator’s Manual
Page 3-5
3.2 DEFAULT SETTINGS
Switch Selections - All switches are placed in the Off position (default) for shipping.
This will result in the following operating configuration:
Communications:
8 data bits, no parity, 1 Stop bit, 9600 Baud
Protocol:
Ready/Busy, Standard Protocol Codes
Print Method:
Thermal Transfer
Head Check: Disabled
Receive Buffer:
Single Job
Pitch Check:
Sensor Used
Software Default Settings - The printer stores the software settings upon receiving them, and
uses these settings until they are again changed by the arrival of new settings. These settings
are stored in non-volatile RAM and are not affected by powering the printer off. The printer may
be reset to use the default software settings by depressing the FEED and START/STOP keys
simultaneously while powering the printer on. This will result in the following default
configuration:
Once the default operation is completed, a “SATO DEFAULT COMPLETED” message
will be displayed on the LCD panel or a single “beep” will be heard if the printer does
not have an LCD panel. The printer should be turned off while this message is being
displayed (or after the “beep” is heard). This saves the default settings in the EEPROM
where they will be automatically loaded the next time the printer is turned on.
XL400e
XL410e
Print Darkness
2
2
Print Speed
6 inches per second
5 inches per second
Print Reference
Vertical=001
Horizontal=001
Vertical=001
Horizontal=001
Media Type
Center Hole Tag
Center Hole Tag
Cutter
Enabled
Enabled
Zero
Slash
Slash
SATO DEFAULT
COMPLETED