SATO CL608e, Service Manual

Page: 27 / 245

Page 2-5
Section 2. Configuration
SATO CL608e/CL612e Service Manual
PN 9001079
Rev. B
DSW3
ON
OFF
1 2 3 4 5 6 7 8
DSW3
ON
OFF
1 2 3 4 5 6 7 8
DSW3
ON
OFF
1 2 3 4 5 6 7 8
DSW3-3 SETTING
Off Sensor Used
On Sensor Not
Used
DSW3-4 SETTING
Off Enabled
On Disabled
DSW3-5 SETTING
Off Disabled
On Enabled
Label Sensor Selection (DSW3-3):
Enables or disables the Label Pitch sensor. If the
sensor is enabled, it will detect the edge of the label and position it automatically. If
it is disabled, the positioning must be under software control using Line Feed
commands.
Back-Feed Selection (DSW3-4):
When Back-Feed is enabled, the printer will
position the label for dispensing/cutting and retract it before printing the next label.
The amount of backfeed is adjustable.
External Signal Interface
The EXT connector on the printer rear panel is intended for use with the external
printer accessories such as label rewinders or applicators. The 14-pin Centronics
type connector provides a choice of four different output signals along with various
error conditions.
EXT Print Start Signal Selection (DSW3-5):
Allows an external device to initiate
a label print for synchronization with the applicator. See Section 3: Interface
Specifications for a description of the signal level and requirements. When DSW3-
5 is On, the unit is in the Continuous print mode, Backfeed is disabled an External
Signals are ignored.
Dip Switch Settings