SATO CL608e, Service Manual

Page: 119 / 245

Page 6-13
Section 6. Replacement Procedures
SATO CL608e/CL612e Service Manual
PN 9001079
Rev. B
STEP PROCEDURE
1. Switch the printer OFF and disconnect the power cable.
2. Remove (3) screws holding the left side cover to the printer. Raise the
access door and loosen the (2) screws on the inside top of the printer.
Lift off the left side cover. Fig. 6-1
3. Remove the ribbon and label stock if installed. Fig. 6-19
4. Refer to Fig. 6-20 & 6-21 Locate Belts "A" and "B" in the electronics
compartment.
5. To remove and replace Belt "A", remove screw that attaches to the
rewind spindle in the electronics compartment. Do not disturb two
adjacent screws. These are used for fine adjustments only.
Figs. 6-22
6. In the mechanical section, gently pull the rewind spindle out to dislodge
Belt "A". Figs. 6-22
7. Inspect bearing for wear and replace as necessary.
8. In the electronics section remove the belt from the gears. Install
replacement belt. Figs. 6-23. Refer to Section 5.8 to adjust belts.
9. To remove and replace Belt "B", loosen adjustment idler. Figs. 6-23
Dislodge Belt "B" from motor shaft and gears. Install replacement belt.
Refer to Section 5.8 to adjust belts.
10. Replace the left side cover and reconnect the power cable.
REMOVE THE
RIBBON AND
LABEL STOCK
Fig. 6-19
6.6 Replacing the Timing Belts