CONN
E
CT
IO
N
Dataloggers SenNet DL150 / DL151 / DL170 / DL171 / DL172. Technical manual
Version 1.01
Satel Spain
41
7.
CONNECTION OF THE DL-171
7.1.
Connection to the power supply
The same instructions as for the DL170 model should be followed (see section
Error! Reference source
not found.
6.1 Connection to the power supply, p. 37).
7.2.
Connection of the antennas: GPRS/3G, Z-Wave (optional) and RF
The terminals of the radio frequency and Z-Wave antennas are SMA (Sub Miniature version A). You
should verify which antenna corresponds to RF and which to GPRS. All dataloggers DL171 have RF and
GPRS outputs.
There are two LED lights that show the status of the RF module. If the radio is active, the bottom LED
will be on. The upper LED will blink whenever the datalogger makes a shipment by RF.
7.3.
USB / Wi-Fi port connection
The same instructions as for the DL150 model should be followed (see section 4.3 USB / Wi-Fi port
connection, p. 24).
7.4.
Ethernet port connection
The Ethernet port is in the opposite side to the terminals and close to the GPRS and RF antennas.
7.5.
GSM/GPRS port connection
The terminals of the radio frequency and Z-Wave antennas are SMA (Sub Miniature version A). You
should verify which antenna corresponds to RF and which to GPRS.
The GSM/GPRS antenna should be installed following the ESD protections
to prevent damage to the device
For further information, see the connection of the GSM / GPRS port for the model DL170 (section 6.5
GSM / GPRS port connection p. 38).
7.6.
Digital-outputs connection
The same instructions as for the DL170 model should be followed (see section 6.6 Digital outputs
connectionDigital , p. 38).
7.7.
Connection of the electricity meters
The same instructions as for the DL151 model should be followed (see section 5.5 Connection of the
electricity meters, p. 26).
Summary of Contents for SENNET DL150
Page 1: ...Dataloggers series Device network DL150 DL151 DL170 DL171 DL172 ...
Page 8: ......
Page 44: ......
Page 86: ......