SATELLINE-3AS and SATELLINE-3ASd
25
66
SETTINGS
SETTINGS
The several settings in the SATELLINE-3AS radio modem can easily be changed. When pin-12 is
connected to ground (GND) radio data modem is turned into SETUP MODE. In the SETUP
MODE the settings of the serial port 1 are 9600 bps, N, 8,1. In this mode the features of
SATELLINE-3AS can be changed in the way described in chapter 6.1.
If the SL-command function is activated the channel and address can be changed without
moving into the SETUP MODE. Settings of the serial port are those set at the SETUP MODE. In
this function the features of SATELLINE-3AS can be changed in the way described in chapter 6.2.
6.1
6.1
Changing the settings using terminal
Changing the settings using terminal
Connect the radio modem to a terminal or a PC that is in terminal mode (use for example
SaTerm or Windows Hyper Terminal program) . Check the correct wiring of the cable from the
wiring diagrams. Terminals data speed should be 9600 bps and the length of the ASCII code
N,8,1. Connect the mode-pin (pin-12) into ground (GND). The radio modem sends the
following message to the terminal:
***** SATEL 3AS *****
SW Version x.yz HW Version 02/01
--------------------------------------------------------------------------------
Current settings
----------------
1) Radio frequency 433.0000 MHz [ CF 433.0000 MHz, Spacing 25 kHz ]
2) Radio settings Tx Power Level 1000 mW / Rx Sensitivity Level -110 dBm
3) Addressing RX Address OFF / TX Address OFF
4) Serial port 1 ON / 19200 / 9 bit data / Even / 1 stop bit
5) Serial port 2 OFF / 19200 / 8 bit data / None / 1 stop bit [ RS-232 ]
6) Additional setup Error Correction OFF /Repeater Function OFF/ SL-commands OFF
7) Tests Test Mode Inactive
8) Restore factory settings
E) Exit
Enter selection >
