22 MTX-300
SATEL
3. Strength of the radio signal of the last received transmission, expressed in dBm.
function
Information on the status of the first registered siren is presented in the leftmost position, on
the status of the second siren – in the second position from the left, etc. Displayed symbols
have the following meaning:
- registered, but has not received all configuration data yet,
- standby,
- communication in progress,
- signaling triggered by transmission from the controller is in progress,
- signaling triggered by opening of the siren tamper switch is in progress,
- opening of the tamper switch will not trigger alarm signaling (device is running in service
mode),
- no communication.
7.2 MTX soft program
Some diagnostic information is presented in the upper part of the program window (see
“Status information” p. 12), and some in the “Diagnostics” tab.
7.2.1 “Diagnostics” tab
The following information is displayed in the table:
Type
– device type: MTX-300, keyfob, detector or siren.
No.
– number of device on the list of devices of given type.
Name
– name of device.
Tamper
– status of the device tamper switch:
- OK (switch closed),
- tamper (switch open),
- tamper memory (switch closed) [red square against green background on the
right].
FTB
– status of the device battery:
- OK,
- low battery.
FTR
– communication status:
- OK,
- no communication.
Level
– information on level of radio signal of the last received transmissions.
On the right-hand side of the window, the following buttons are available:
Clear measur.
– click to reset the data related to radio signal level.
Clear tmp memory
– click to clear the tamper memory.
RF review
– click to see the radio band occupancy diagram. It presents both noise level and
signals received from other radio devices operating on the same frequency band.
8. Default factory settings
Service code: 1111
