SATEL MTX-300
21
You can also enter the diagnostic menu from the service menu (
function). The
controller remains then in the service mode, i.e. you cannot trigger signaling using inputs and
tamper alarm signaling in sirens is blocked.
7.1.2 Exiting diagnostic menu
1. Scroll through the list using the
or
button, until
is displayed.
2. Press the button.
5 minutes after the last button press, automatic exit from the diagnostic menu will
follow.
If the diagnostic menu is entered from the service mode, automatic exit from the
diagnostic menu will only follow, if no siren is registered in the controller.
7.1.3 List of diagnostic functions
check which wireless device reports low battery (the function is available when FTB output is
on)
check with which detector or siren there is no communication (the function is available when
FTR output is on)
check which device (detector or siren) has reported tamper (if device is not already reporting
tamper, this is indicated by the symbol displayed in the leftmost position – after exiting the
function, the tamper memory will be cleared)
check the level of radio signal received from wireless devices
check siren status (the function is available, if at least 1 siren is registered in the controller)
check information on the controller firmware version
return to service menu (the function is available, if the diagnostic menu has been entered
from the service menu)
exit the menu (if the diagnostic menu has been entered from the service menu, this will also
exit the service mode)
function
After starting the function:
the first character on the display presents graphically information on the level of radio
signal:
- very good signal level,
- good signal level,
- poor signal level,
blank – very poor signal level.
next characters provide information on the device to which presented signal level refers:
[+number] – keyfob,
[+number] – detector,
[+number] – siren.
You can scroll through the list using the
or
button.
Press the
button repeatedly to get detailed information about the level of signal received
from the given device:
1. Radio signal level presented as percentage..
2. Average strength of the radio signal, based on 3 last received transmissions, expressed in
dBm (dot is displayed after the indicated value).