SATA 51075, User Manual

Page: 18 / 84

中文
EN DE RU KO PT JA ES 51075
18
Operation guideline:
Caution:
Please read the instruction carefully before operating the machine.
Before the use:
1. Charging:
The charger shall be used with the machine tool. Using other chargers is not allowed.
The machine tool is equipped with a protective circuit. When the battery level is low, the protective circuit will open and the machine tool
will stop rotating.
The machine tool may heat up in higher temperature environments or after long use. In this case, please do not immediately charge it
until it has cooled down, or else the service life of the battery will be shortened or it will not be possible to charge the battery due to
overheating.
When the machine tool is charged for the first time or is not used for a long time, the efficiency of the charger may only reach about
60%, and should reach 100% again after 2–3 instances of charging and discharging.
2. Installation/removal of battery pack
（
see Figure A
）
:
To remove the battery pack, press down the lock button in front of the battery pack and pull it out. To insert the battery pack, just push it
into the machine tool. Do not apply excessive force.
A B
1
C
2
D E
2
1