Operating Instructions YTM15MA
23
Operation
t
Place the connector (1) of the measurement cable
into the temperature measuring device .
t
NOTICE
Observe the information in Chapter 4 .2,
Page 9 . Use the disk holder to position the
adjustment disk (2) on the pan retainer .
t
Close the hood .
y
The measurement starts with the following
sequence:
− 0 .0 to 49 .9 minutes: Display "CAL H1" .
− 50 .0 to 69 .9 minutes: Display "CAL H2" .
− 70 .0 to 84 .9 minutes: Display "CAL H3" .
− 85 .0 to 99 .9 minutes: Display "+ x .x," .
− Output display "+ 0 .0 ." "Beeps" 5x every 10 sec .
until one of the two "+/- cursor keys" is
confirmed for the first time .
t
If the temperature discrepancy is within the
tolerance (after 85 minutes): Press [CF] to exit the
program .
NOTICE
It is essential to observe the conversion table on
page 25 .
t
If the temperature discrepancy is outside of the
tolerance (between 85 and 100 minutes): Correct
the temperature using the cursor keys [+/-] .
t
Enter the correction values: Positive values for a
temperature that is too low, negative values for a
temperature that is too high .
t
To confirm the correction: Hold down the [ENTER]
key .
y
A printout is generated .
If no correction entry with a confirmation is made
before 100 minutes, the calibration cancels
automatically with "Err C ."
1
2
