37
Moisture Analysis
Operating Instructions Moisture Analyzer MA37
y
The current measurement value and progress are shown on the display during
the moisture analysis .
t
65.00
%M
Standard
Fully automatic
110
°C
09:41 min
67.50 %M
– If a target value is set, the measurement process is displayed as a bar diagram .
The target value is marked and tolerance limits are displayed .
67.00
%M
Standard
Fully automatic
110
°C
09:41 min
+
– If no target value is set, the measurement process is displayed as a curve
diagram .
The following information is also shown on the display:
– Information bar at the top right: measurement time expired
– Function bar below: method name, target temperature, switch-off criterion
t
To cancel the moisture analysis before it is finished: Select
<
.
y
When the moisture analysis is finished, the moisture content of the sample is
shown on the display .
The process status light on the analyzer flashes three times and then goes out .
t
67.53
%M
Standard
Fully automatic
110
°C
11:18 min
Measurement completed
i
OK New
n
67.50 %M
– If a target value is set, the moisture content is displayed as a bar diagram .
– Bar is green: Result is within the tolerance limits .
– Bar is red: Result is not within the tolerance limits .
– Bar is orange: Measurement was canceled .
85.15
%M
Standard
Fully automatic
110
°C
11:18 min
OK New
n
Measurement completed
i
– If no target value is set, the moisture content is displayed as a curve diagram .
t
Select the desired option:
– To perform another moisture analysis using this method:
Select
NEW
.
– To view the report and print it out if desired: Select
n
.
– To exit the measurement: Select
OK
.
