User Manual
.
Version 1.2
17
Remote Controller Button Descriptions
Fig
Area
Name
Description
Top Row
Active/Power Saving
Toggles the states of the TX and RX between
Active mode and Power Saving mode. Power
Saving mode is the state you can set the TX
and RX to when not in use. In Power Saving
mode, the RX & TX stop sending video to the
TV monitors and then revert to a low-power
state. These devices, although in Power Saving
mode, can still continue to deliver Ethernet
data in the background (see Chapter
“
Ethernet over PLC Function”
). The Power
Saving mode for the RX and TX are
independent of each other and must be set at
their respective locations.
Top Row
Link
Re-establishes a PLC connection between the
TX and the RX.
Top Row
Group
Use this button if the RX and TX cannot
establish a connection (cannot be paired). You
also need to use this button when adding an
additional RX to your existing RX/TX
environment (or group.). This button is also
used to allow the RX/TX to reset the system to
factory defaults.
Top Row
Factory (only for RX)
Resets the RX PLC to the factory default
settings.
Source
Select next source
Selects next input source of the TX. Similar to
the “Source” button on the TX. It is used to
switch from the current input source to next
(e.g. HDMI, AV1, AV2 etc).
Source
Select HDMI-1
Change current TX input source to HDMI-1
Source
Select previous source
Move backwards to the previous TX input
source. It is the opposite of “Select next
source”.
Source
Select AV2
Change current TX input source to AV2
(YPbPr)
Source
Select AV1
Change current TX input source to AV1
(CVBS/S-Video)
Source
Not in use
Reserved
Volume
Increase Volume (for RX)
Increase audio volume on the receiver
