User Manual
.
Version 1.2
28
Appendix 4
Reset RX/TX PLC to Factory Defaults
The RX/TX PLC Factory Default settings are different from the RX/TX System
Default settings described in Appendix 3. These procedures are used when
attaching an additional RX to your system or when troubleshooting your system.
a) At the TX, press the
(
Factory Button) on the remote controller
AT LEAST
3
TIMES
(in rapid succession) until all the source LEDs on the front panel go
off-on-off-on and the system will reboot automatically.
b) At the RX, press the
(Factory
button) on remote controller until the
screen message displays on the TV, as
shown on the right. Press the “OK”
button to reset the defaults (you can
press any other button to exit the
operation).
Note:
See “Adding an additional RX” section or “Troubleshooting section for
proper use of these procedures.
