RECORD settings
36
• ALARM (P18)
Recording is performed as soon as a sensor device
connected to the external alarm input terminal (ALARM IN)
of this unit reacts.
• SCHEDULE (P19)
Recording is performed daily during the set time slot set
on the TIMER SET screen in the recording settings.
• DISABLE
No recording is performed.
●
Setting the MOTION ZONE (Refer to "MOTION
recording": P17)
Select the zone where the motion sensor is active. It is
necessary to set a detection frame when PARTIAL ZONE is
selected.
• FULL ZONE:
The motion sensor is active on the whole screen.
• PARTIAL ZONE:
The motion sensor is active in the set detection frame.
●
Setting the MOTION SENSITIVITY
To select "MOTION SENSITIVITY" and select the level of
detection sensitivity of the motion sensor.
Selections:
1/2/ ... 8/9 (Low sensitivity level)
●
Setting the ALARM RECORDING
Up to a maximum of 4 alarm input terminal numbers can be
set to activate ALARM recordings.
ALARM recording is performed when an external alarm signal
is input to the specified terminal.
●
Setting the PRE RECORD
To select "PRE RECORD" and select pre-recording.
ON:
Starts recording approximately 5 seconds before the
internal motion sensor or the external sensor detector
is triggered. (Fixed to 1 ips)
OFF:
No pre-recording
●
Setting the POST EVENT RECORD
To select "POST EVENT RECORD" and select in how
much time, after the sensor detection, the recording will
start.
Selections:
2/3/4 ... 30 SECONDS
●
Setting the AUDIO
To select "AUDIO" and set the audio sound recording.
ON:
Records the audio of live videos
To listen to audio sound connect an external
microphone or speaker.
OFF:
Does not record the audio of live videos.
To perform SCHEDULE settings.
The recording schedule of each channel can be set using
settings by the hour. (P19)
Only CH1 - CH4 can record AUDIO.
C
Setting the TIMER SET
