5
Instruction Manual for Sanuvair
®
S300
1-888-726-8869
www.sanuvox.com
4. While holding the UV lamp by its porcelain end-cap, slide it into the
rectangular opening in the front of the unit (above the filters and motor
access door).
STEP 4
STEP 5
STEP 6
5. Carefully push the white connector onto the four pins. The plug is
designed so it can only be installed one way. You may have to rotate the
socket 90° to line up the pins with the holes. The connector will fit into
position.
NOTE:
Too much force applied from the opposite end-cap may break
the lamp.
6. Then, slide the porcelain tip through the retention clamp.
NOTE: Make sure the lamp is horizontal in this section and not touching
the metal walls.
STEP 7
STEP 8
7. Take the access door for the lamp and ballast from the supplied
accessories and position it over the rectangular opening. Secure the
plate in place with the 6 screws provided for this purpose.
8.
Close the filters and motor access door
of your S300 unit.
You are now ready to install your S300 unit in one
of the three suggested installation types.
