User manual
SNC-8322I / SNC-8322HO
_________________________________________________________________________________
- 56 -
Send alarm message by FTP/e-mail:
The administrator can select whether to send an alarm message by FTP and/or
e-mail when an alarm is triggered.
Upload image by FTP:
Select this item and the administrator can assign a FTP site and configure various
parameters. When the alarm is triggered, event images will be uploaded to the
appointed FTP site.
The <Pre-trigger buffer> function allows users to check what happened to cause the
trigger. The <Pre-trigger buffer> frame rate can be pre-determined.
The <Post-trigger buffer> allows to store a certain amount of images after the alarm
input is triggered.
Check the box <Continue image upload> to upload the triggered images during
certain time or keep uploading until the trigger is off. Select
<Upload for … sec> and
enter the duration in the field (1-99999). The alarm images are stored on the FTP site.
Select <Upload during the trigger active> to make the images keep being uploaded to
FTP until the alarm trigger is released. Set the image frequency as the upload frame
rate (1-15 frames).
Note:
Make sure the FTP configuration has been completed.
Also refer to chapter 2.3.4.2 FTP server” for further details.
Record stream to SD card:
Select this item and the alarm-triggered recording will be stored on the micro
SD/SDHC card.
The <Pre-trigger buffer> recording function allows users to check what happened to
cause the trigger. The pre-trigger buffer time range is from 1 to 9 seconds.
Select <
Upload for … sec> to set the recording duration after alarm is triggered.
The setting range is from 1 to 9999 seconds.
Select <Upload during the trigger active> to record the triggered video until the trigger
is off.
Note:
Please make sure that a micro SD/SDHC card is inserted into the camera in order to
make the recording work.
Also refer to chapter “2.3.9 Recording” for further details.
Upload image by e-mail:
The administrator can assign an e-mail address to which images are sent in case of a
triggered alarm.
The <Pre-trigger buffer> function allows users to check what happened to cause the
trigger. The <Pre-trigger buffer> frame rate can be pre-determined.
The <Post-trigger buffer> allows to store a certain amount of images after the alarm
input is triggered
