Operation
Always start with a cleaned and sanitized dispenser as per previous instructions. Use only fresh mix when charging
the units. Adherence to these instructions is critical to the maximum operating efficiency of the machine.
1. Turn
on
the
premix
supply system to the unit.
2. Set
the
fil
l
switch (Fig. 15) to the "ON" position.
Fig. 15
Control Switch
3. Simultaneously, open the spigot and dispense
enough of the product to purge the system of
sanitizing solution (approximately 16 ounces).
Close the spigot plunger and fill the freezing
chamber. When the mix pan probes are satis-
fied, the
"MIX OUT"
light goes off.
4. Set the dasher and refrigeration switches to the
"ON" position. Both the dasher and compressor
will start. Note: Dasher switch must be set to
"ON" first. Alight clicking noise may be heard as
the dasher turns until the product in the freezing
cylinder freezes.
5. Allow the compressor to cycle 3-4 times dispens-
ing a sample of the product after each cycle to
check for desired consistency. If the machine is
not dispensing the product at the desired consis-
tency after four full cycles, refer to the Consis-
tency Adjustment section of this manual. Initial
pull-down time is 8-10 minutes, but may vary due
to product and ambient conditions.
6. Replace the side panel when the desired consis-
tency is obtained.
10
