13
SANIFOS
®
110 P,
SANIFOS
®
280 and SANIFOS
®
610
•
Connect the pipeline(s) to each pump (delivered separately).
•
Once the connections have been made, lower the submersible pump(s) and their piping inside the tank and
reconnect the pipes.
•
SANIFOS
®
280 with extension and SANIFOS
®
610 (1 pump) :
Attach the chain to the pump and connect to the top
of the tank using the hook provided for this purpose (useful during maintenance
of the device).
•
SANIFOS
®
610 (2 pumps) :
Attach each end of the chain to a pump using a snap
hook. Attach the third snap hook in the middle of the chain then on the top of the
tank.
•
Please check the positioning of the pumps in the tank as in the photo opposite.
SANIFOS
®
1300 :
•
Attach the chain to the pump and connect to the top
of the tank using the hook provided for this purpose
(useful during maintenance of the device).
•
Slide the pumps on the guide bars to the bottom
of the tank.
4.3 Electrical wiring
4.3.1 Wiring of pumps and floats
Use of waterproof terminal blocks (SANIFOS
®
280, SANIFOS
®
610 and SANIFOS
®
1300)
The connection with the waterproof terminal block makes it possible, when servicing the submersible pumps, not to
disconnect the power cables and not to pull the 10 m cable through the cable glands or through the ventilation duct used
for their passage in order to be able to remove the pumps from the tank.
Wiring the waterproof terminal blocks (4 conductors) for pumps
➜
Terminal block TH400 5P (use only 4 poles)
Wiring the waterproof terminal blocks for floats
➜
Terminal block TH391 2P
NOTE
On SANIFOS
®
610 and SANIFOS
®
1300, the floats are delivered with the tank and
must be connected to the SMART control box via the TH391 2P waterproof terminal
blocks. It is imperative that you respect the colours of the cables when making the
connections (black/black, brown/brown, grey/grey)
