S&P UTBS PRO-REG Series, Manual

Page: 51 / 72

51
door which gives access to the electronic board. Remove all the connectors attached to
the controller with the exception of the 4-way electrical supply green plug connected to
terminals 1,2, Earth and 4.
A 05 95 A 04 94 A 03 93 A 02 92 A 01 91 Agnd 90 DI 8 78 DI 7 77 DI 6 76 DI 5 75 DI 4 74 DI 3 73 DI 2 72
E 63
Ext.
Disp.
N 62 A 61 B 60 E 53
P 1
A 51 B 50
P 2
P 1 Rx
Tx
P 2 Rx
Tx
TCP / IP
P / B
N 52
DI 1 71
TCP / IP
45 UI4 44 UI3 43 Agnd 42 UI2 41 UI1 40 A
GND
35 AI4 34 AI3 33 Agnd 32 AI2 31 UI
1
30 Agnd 17 D07 16 D06 15 D05 14 D04 13 D03 12 D02 11 D01 10 GD0 4 +C 2 G0
-
1 G
+
TCP / IP
45 UI4 44 UI
3
43 Agnd 42 UI
2
41 UI1 40 A
GND
35 AI4 34 AI3 33 Agnd 32 AI2 31 UI1 30 Agnd 17 D07 16 D06 15 D05 14 D04 13 D03 12 D02 11 D01 10 GD0 4 +C 2 G0
-
1
G+
A 05 95 A 04 94 A 03 93 A 02 92 A 01 91 Agnd 90 DI 8 78 DI 7 77 DI 6 76 DI 5 75 DI 4 74 DI 3 73 DI 2 72
E 63
Ext.
Disp.
N 62 A 61 B 60 E 53
P 1
A 51 B 50
P 2
P 1 Rx
Tx
P 2 Rx
Tx
TCP / IP
P / B
N 52
DI 1 71
With a screwdriver, release the controller from the DIN rail on which it is mounted.
To reset the controller, it must be under voltage so re-energise the UTBS PRO-REG at the
isolator and also on the unit by switching back on the main switch.
To reset the controller use a clip as shown in the picture: connect the ETD remote control
cable and hook the Corrigo back onto the DIN rail. DO NOT CONNECT ANY OTHER PLUGS –
AT THIS POINT, ONLY THE ETD REMOTE CONTROL AND 4-WAY ELECTRICAL SUPPLY PLUG
SHOULD BE CONNECTED TO THE CORRIGO.
When the ETD cable and 4-Way electrical supply plug have been connected, perform the
following sequence of operations: