627-500
13
INSTALLATION
To Close Doors and Panels
Enclosure Door
Step 5
Release the doorstop, and push and hold the
door closed. Then rotate the handle counter
clockwise to engage the latch points. See
Figure 3.
Step 6
Pull outward on the handle cover to verify
that the door has latched securely and insert a
padlock into the hasp.
Rear Access Panels
Step 7
Release the doorstop and tighten the three bolts
by rotating the wrench, or other appropriate
tool, clockwise until the bolts are suffi ciently
tight.
Step 8
Pull outward on the access panel to verify that
the door has latched.
Placement
Step 9
Transport the switchgear to the installation
site observing the precautions given under
“Handling” on page 9.
Step 10
At the installation site, remove all the separately
packaged components, which were shipped
within the module, and set them aside.
Step 11
Each module of an assembly is identifi ed by a
number on the front of the module See Figure 5.
Proper positioning of the module is indicated
on the anchor-bolt plan of the “CDA” drawing,
enclosed in the waterproof envelope labeled
“Instruction Manual.”
Figure 5. Location of module identifi cation.