S&C Instruction Sheet 1041-550
31
IntelliLINK
Battery System
The
SETUP: Battery System
screen (Figure 13) shows the status of the battery system.
To display the SETUP: Battery System screen:
Click the
Setup
button at any IntelliLINK screen, then click the
Battery System
button.
Figure 13. Setup: Battery System screen.
The upper part of this screen allows you to view the factory-defined values for this switch
installation. The lower part of the screen displays real-time battery data.
This screen includes the following fields:
Battery Voltage “Low” Setpoint (Volts DC)
When the battery voltage is between this value and the
Battery Bad
value, switch operation
is still possible but only for a limited time. When the
calculated voltage under load
drops
below this value, the switch control displays a
Battery Low
message.
Battery Voltage “Bad” Setpoint (Volts DC)
The switch will not reliably operate at voltages below this value. When the
calculated volt-
age under load
drops below this value, the switch control displays a
Battery Bad
message.
Load Resistance Factor
This is a correction factor that the switch control applies to the calculation of battery
voltage under load. The correct value is entered at the factory.
Summary of Contents for 5800 Series
Page 34: ...Printed in U S A...