Samwon Tech SDR100E Series, Instruction Manual

Page: 8 / 110

6
1-2. Exterior and how to install
(1) Installation location and environment
Cautions for the installation location and environment Installation Precautions
●
This product is an industrial product.
●
Please manipulate in electricity on state at the installation of this product
on the panel because of the electric shock risk. (Caution for electric shock)
●
Do not install the product in the following location or environment.
- A place for contacting the terminal by the human without recognition
- A place directly exposed for mechanical vibration or impact
- A place exposed for the corrosive gas or flammable gas
- A place of temperature fluctuation
- A place of extremely high (Over 50
℃
) and low (Under 10
℃
) temperature
- A place exposed to the direct sunlight
- A place influenced with electromagnetic wave
- A place of moisture (A place with more than 85% of humidity)
- A place where there are the flammable stuffs at the surrounding
- A place of dusty and salty
- A place of receiving the ultra violet light
●
Do not use sharp thing or excessive pressure to manipulate the touch
screen.
●
Please pay attention to the handling of the product because the product is
weak to the organic solvent (Chemical substances) as the exterior of the
product is made of plastic.
(Do not contact the front side of the product to
the organic solvent especially.)
●
Even though the case of this product is made of non flammable material
such as ABS/PC, but do not install in the place where there are the stuffs of
easy flammability.
●
Don’t put the device or the wiring which cause the noise near to this
product.
●
Use the product in 10~50
℃
, in 20~90% RH (It shall not be dewing.) Don’t
put the heat radiant device closely.
●
Don’t install the product in declined position.
●
Keep the product in -5~70
℃
(It shall not be dewing.). Especially, use after
full warming up (Switch on) when you use the product under 10
℃
.
●
The wiring work shall be made after switching off electric power on the
machine.
●
This product operates in 24V DC, 22V max without special manipulation.
There is a risk of the electric shock or fire when the electric power other than
the specification.
●
Don’t work with wet hands. It has the risk of electric shock.
●
Follow up the basic cautions to reduce risk of fire, electric shock and injury
during using.
●
The installation and the use shall be made according to the specified
methods in instruction manual.
●
Refer to the installation procedure regarding to the description for ground.
However, do not make the ground on the water supply pipe, gas pipe, phone
line and lightening rod.
There is a risk of explosion and fire.
●
Do not switch on before finishing the connection of the devices. It may
cause the failure.
●
Do not close the heat radiating hole on this product. It may cause the
failure.
●
This product can be used under the following environmental conditions.
- Indoor
- Altitude up to 2000m
- Pollution degree II
- The level of excessive voltage protection category II