OPERATION
16
USER’S MANUAL
2. FRONT PANNEL CONTROLS
2-1. POWER ON / OFF
After the connection of power cord and other devices with SVR-1620, Turn the power on.
a. The video signal system (NTSC or PAL) is automatically
detected.
b. Power Failure Recovery
SVR-1620 automatically reverts back to programmed record
parameters upon power restoration.
c. If the power key is protected by password, the power on/off
cannot be executed before input the correct password.
(Refer to the Password Setup in the main menu)
2-2. SCREEN DISPLAY
2-2-1. Multi Display & Full Screen display
a. Multi display
To change a single camera display to the multi camera, press the Multi button.
b. Full screen display
Press the desired camera number button you wish to display on the monitor.
•
Before the power of SVR-1620 is on, check the input power currency in advance and select
the indication of power input (230V=180V~265V, 115V=90V~135VAC)at the rear-side of DVR
•
If there is no video signal, the video signal system is set to NTSC. Do not input the PAL type video signal or it may
cause SVR-1620 malfunction. In this case, turn off and on again.
The number of the camera select buttons are used to set the password In the Password Lock function.
