3-7
♦
If 3 PPPoE is selected ??????????????
Setting IP Manually
If ‘1.Manual IP’ is selected in Mode, sub menu 2 to 4 will be displayed on the
LCD panel.
The user may directly enter the IP address, subnet mask, and gateway, address as
follows:
♦
If the ‘2.IP’ menu is selected, the LCD panel will show the following message
and the user can enter the ITP phone’s IP address.
Check if there is any currently saved IP address of the phone on the LCD panel. If
the IP address has not been set, the LCD panel shows nothing. The user can enter
the IP address by using the dial buttons and [*] button to enter ‘.’. After the
correct IP address has been entered press the [Enter] button to save the setting.
♦
If the ‘3.Netmask’ menu is selected, the LCD panel will show the following
message and the user can enter a new Netmask IP address.
Check if there is any currently saved subnet mask address of the phone on the
LCD panel. If the subnet mask address has not been set, the LCD panel will show
nothing. Enter the Netmask using the dial buttons and [*] button to enter ‘.’. After
* Input Netmask
xxx.xxx.xxx.xxx
* Input IP Address
xxx.xxx.xxx.xxx
Network (2/4)
1.Mode
2.IP
3.Netmask
4.Gateway
Summary of Contents for OfficeServ ITP-5012L
