English
63
Maintaining y
our
appl
ianc
e
4.
Lower the oven door to the fully open
position. If the oven door does not open to a
full 90 °, repeat steps 1 through 3.
5.
Locate the oven door hinge locks in the
corners of the oven door, and rotate the
hinge locks toward the oven cavity to the
locked position. See Step 3 (illustration A) in
the
Removing the oven doors
section for the
proper locked position.
6.
Close the oven door.
7.
When the hinges are properly installed and
the door is closed, there should be an even
gap between the door and the control panel.
If one side of the oven door is hanging lower
than the other, the hinge on that side is not
properly installed.
8.
Reconnect the LED light's Wire Harness and
re-insert the rubber.
CAUTION
After replacing the door, make sure to reconnect the wires. Push them inward to arrange
them as they were before you removed the door. Wires that are not connected or arranged
correctly can be caught in the door or damaged by heat.
Replacing the oven doors
CAUTION
The door is very heavy. You may need help lifting the door high enough to slide it into the
hinge slots. Do not lift the door by the handle.
A
A.
Slot in the oven cavity for the door
hinge lock
1.
Using two hands, grasp the side edges of the
door at the midpoint. Face the oven cavity.
2.
Locate the slots on each side of the oven
cavity for the door hinge locks.
3.
Hold the door at a 45 ° angle, and then align
the door hinges with the slots in the lower
front of the oven cavity. Slowly insert the
door, making sure you maintain the 45 °
angle. You will know the door is engaged in
the slot when you feel a slight drop.
Summary of Contents for NV51 700S Series
Page 1: ...Built InElectricWallOven Usermanual NV51 700S ...
Page 71: ...Memo ...