English
61
Maintaining y
our
appl
ianc
e
5.
Repeat for the right (front and back) slide
mechanism of the rack.
6.
Open and close the rack several times to
distribute the lubricant.
7.
Replace the cap on the lubricant and shake
it again. Turn the rack over and repeat steps
3, 4, 5, and 6.
8.
Close the rack, turn the rack right-side-up,
and then place in oven. See
on page
.
NOTE
Do not spray the gliding rack with cooking spray
or other lubricant sprays.
Oven door
Don’t hand
Don’t hand
clean the oven
clean the oven
door gasket.
door gasket.
You may
You may
hand clean
hand clean
the door.
the door.
•
Use soap and water to thoroughly clean
the top, sides, and front of the oven door.
Rinse well. You may use a glass cleaner on
the outside glass of the oven door. DO NOT
immerse the door in water.
DO NOT spray
or allow water or the glass cleaner to enter
the door vents.
DO NOT use oven cleaners,
cleaning powders, or any harsh abrasive
cleaning materials on the outside of the
oven door.
•
DO NOT clean the oven door gasket.
The
oven door gasket is made of a woven
material which is essential for a good seal.
Care should be taken not to rub, damage, or
remove this gasket.
To lubricate the slides of the gliding rack
1.
Remove the rack from the oven.
See removing the gliding rack in the
section on
page
.
2.
Fully extend the rack on a table or
countertop. Newspaper may be placed
underneath the rack for easy cleanup.
3.
If there is debris in the slide tracks, wipe
it away using a paper towel. (Any graphite
lubricant wiped away must be replaced - See
steps 4 through 7).
4.
Shake the graphite lubricant before opening
it. Starting with the left (front and back) slide
mechanism of the rack, place four (4) small
drops of lubricant on the two (2) bottom
tracks of the slide close to the bearing
carriers.
Summary of Contents for NV51 700S Series
Page 1: ...Built InElectricWallOven Usermanual NV51 700S ...
Page 71: ...Memo ...