Samsung ND-L6013R, User Manual

Page: 115 / 170

3. Click the [ test ] button to see if you can successfully connect to the NAS.
J
`
If the success message is displayed, it means that you can successfully save data in the NAS.
`
If the fail message is displayed, check the following.
-
Confirm that the IP address of the NAS is valid.
-
Confirm that the ID/password of the NAS is valid.
- Confirm that you can access the folder designated as the default folder using the ID of the
NAS.
- Confirm that the NAS SMB/CIFS items are unchecked.
-
Confirm that the NAS IP address and the camera IP address are in the same format.
ex) The NAS & camera subnet mask initial value is 255.255.255.0.
If the IP address is 192.168.20.32 then the NAS IP address should be in the range of
192.168.20.1~192.168.20.255.
-
Check whether you tried to access as another user without formatting the default folder saved
or used.
-
Confirm that you used recommended NAS equipment.
4. After the settings are completed, set the NAS unit to < on >.
5. Click the [ apply ( ) ] button.
6. Log in the NAS and check the < free size > and < total size >.
You can format the default folder specified in the NAS connection setting by clicking
the < format > button.
`
Since data may not be saved after a temporary network interruption when using NAS, it is
recommended that you use SD at the same time to prevent loss of recorded images.
`
The data traffic will increase when the camera is set to higher resolution, higher bit rate, and/or higher
framerate.
If there is too much data traffic, some frame may be skipped although it is stored in a full frame.
`
When a frame skip occurs, images are saved at the rate of min. one image per sec.
English _115
●
Setup
Screen