8
ENGLISH
9
INSTaLLING yoUr mICrowavE ovEN
Place the oven on a flat level surface 85 cm above the floor. The surface
should be strong enough to safely bear the weight of the oven.
1.
When you install your oven, make sure there is
adequate ventilation for your oven by leaving at least
10 cm (4 inches) of space behind and, on the sides
of the oven and 20 cm (8 inches) of space above.
2.
Remove all packing materials inside the oven.
Install the roller ring and turntable.
Check that the turntable rotates freely.
3.
This microwave oven has to be positioned so that plug is accessible.
If the supply cord is damaged, it must be replaced by a special cord or
assembly available from the manufacturer or its service agent.
For your personal safety, plug the cable into a 3-pin, 230 Volt, 50 Hz,
AC earthed socket. If the power cable of this appliance is damaged, it
must be replaced by a special cable.
Do not install the microwave oven in hot or damp surroundings like
next to a traditional oven or radiator. The power supply specifications
of the oven must be respected and any extension cable used must
be of the same standard as the power cable supplied with the oven.
Wipe the interior and the door seal with a damp cloth before using your
microwave oven for the first time.
SETTING THE TImE
Your microwave oven has an inbuilt clock. When power is supplied, “:0”,
“88:88” or “12:00” is automatically displayed on the display.
Please set the current time. The time can be displayed in either the 24-hour
or 12-hour notation. You must set the clock:
• When you first install your microwave oven
• After a power failure
Do not forget to reset the clock when you switch to and from summer
and winter time.
1.
To display the time in the...
24-hour notation
12-hour notation
Press the
Clock
( ) button once or twice.
2.
Set the hour with the
h
button and the minutes with
the
min
button.
3.
When the right time is displayed, press the
Clock
( )
button again to start the clock.
result :
The time is displayed whenever you are
not using the microwave oven.
wHaT To Do If yoU arE IN DoUbT or HavE a
probLEm
If you have any of the problems listed below try the solutions given.
This is normal.
•
Condensation inside the oven.
• Air flow around the door and outer casing.
• Light reflection around the door and outer casing.
• Steam escaping from around the door or vents.
The oven does not start when you press the
Start
( ) button.
•
Is the door completely closed?
The food is not cooked at all.
•
Have you set the timer correctly and/or pressed the
Start
( ) button?
• Is the door closed?
• Have you overloaded the electric circuit and caused a fuse to blow or a
breaker to be triggered?
The food is either overcooked or undercooked.
•
Was the appropriate cooking length set for the type of food?
• Was an appropriate power level chosen?
Sparking and cracking occur inside the oven (arcing).
•
Have you used a dish with metal trimmings?
• Have you left a fork or other metal utensil inside the oven?
• Is aluminum foil too close to the inside walls?
The oven causes interference with radios or televisions.
•
Slight interference may be observed on televisions or radios when the
oven is operating. This is normal. To solve this problem, install the oven
away from televisions, radios and aerials.
•
If interference is detected by the oven’s microprocessor, the display
may be reset. To solve this problem, disconnect the power plug and
reconnect it. Reset the time.
If the above guidelines do not enable you to solve the problem, contact
your local dealer or SAMSUNG after-sales service.
10 cm
behind
20 cm
above
10 cm on
the side
85 cm of
the floor
MW73AD-XTL_DE68-03794M-01_EN.indd 8
2014-05-16 �� 9:22:15
