1
Remove the screws on the rear of the PDP panel.
2
Connect insulation holders to screws (see the illustration below).
• If you are uncertain about installation, hire an Installation Specialist to install the
wall mount bracket.
• Be sure to check that the insulation holders are completely secured on both the left
and right side after hanging the PDP on the wall mount bracket.
• Be careful to avoid getting your fingers caught during installation.
• Make sure the wall attachment panels are tightened. Otherwise the PDP may fall.
3
Tighten the screws of the Insulation holders to the back of the PDP.
Note
• A 5 inch(12.7 cm) gap is needed between the back of the Plasma TV and the wall.
4
Put the 4 insulation holders on the PDP in the grooves of the wall mount bracket and
pull down on the PDP (
Œ
) to secure it to the wall mount bracket. (
´
) Tighten the
screws as shown (
ˇ
) so that the PDP cannot be separated from wall mount bracket.
Fixing the PDP panel to the wall attachment panel bracket
PDP panel
Wall attachment panel bracket
Wall
Œ
´
ˇ
31
Summary of Contents for HP-P5091
Page 1: ...Owner s Instructions HP P5091 with WIRELESS HOME AV CENTER ...
Page 54: ......
Page 76: ......
Page 83: ...83 Memo ...
