Samsung CFTD2083TX/SMS, Service Manual

Page: 29 / 102

Disassembly and Reassembly
Samsung Electronics 3-19
3-3-26 Damper Capstan, Motor Capstan Ass’y
Removal
1) Remove the Damper Capstan
Œ
in the direc-
tion of arrow.
2) Remove the 3 Screws
´
.
3) Remove the Motor Capstan Ass’y
ˇ
.
Assembly :
1) Match the 3 holes of Motor Capstan Ass’y
ˇ
to
the 3 holes of Main Base. Be careful not to drop
or knock the Motor Capstan Ass'y
ˇ
.
2) Tighten the 3 Screws
´
in the direction of
arrow as shown detail drawing.
3) Assemble the Damper Capstan
Œ
.
Note
: After tightening screws, check if there is
gap between the head of screws and the top side
of Main Base. There should have no gap between
the head of screws and the top side of Main Base.
After reinstalling, adjusting the tape transport
system again.
B
C
A
´
3 SCREWS
Œ
DAMPER CAPSTAN
ˇ
MOTOR CAPSTAN ASS'Y
3-3-27 How to Eject the Cassette Tape
(If the unit does not operate on condition that
is inserted into housing ass’y)
1) Turn the Gear worm
Œ
clockwise with screw
driver.(Refer to arrow)
(Other method : Remove the Screw of Motor
Load Ass'y, Separate the Motor Load Ass'y)
Œ
GEAR WORM
Fig. 3-32 Damper Capstan,Motor Capstan Ass’y Removal
Fig. 3-33 How to Eject the Cassette Tape
2) When Slider S,T are approched in the position
of unloading, rotate holder Clutch counter-
clockwise after inserting screw driver in the
hole of frame's bottom in order to wind the
unwinded tape.
(Refer to Fig.3-34)
(If you rotate Gear Worm
Œ
continuously
when tape is in state of unwinding, you may
cause a tape contamination by grease and tape
damage.
Be sure to wind the unwinded tape in the state
of set horizently.)
3) Rotate Gear Worm
Œ
clockwise using screw
driver again up to the state of eject mode and
then pick out the tape.(Refer to Fig.3-33)
FRAME
Fig. 3-34