Samson Trovis 6493, Mounting And Operating Instructions

Page: 37 / 128

EB 6493 EN 7-1
Start-up and configuration at the device
7 Start-up and configuration at the device
The work described in this section is only to be performed by personnel appropriately quali-
fied to carry out such tasks.
Before start-up, make sure the following conditions are met:
−
The compact controller is properly mounted according to the instructions.
−
The electrical connection is properly performed.
After applying the supply voltage, the compact controller is ready for use.
Î
When potentiometers are used, perform a zero and span calibration (see '-CO- ADJ Cal-
ibration of analog inputs and analog output' in the 'Operation' section).
7.1 Configuration
The controller is configured in the configuration level. In the configuration menu, the control -
ler is adapted to its control task by changing individual configuration items and parameters.
Annex A contains an overview of all possible settings that can be made. The Configuration
Manual
u
KH 6493 contains detailed descriptions on individual configuration items as well
as other helpful information.
You can enter the configuration data into the configuration protocol (see Annex A).
Configuration level
You can configure functions and parameters of the compact controller to adapt to a specific
control task. The configuration level has nine menus assigned to functions and their parame
-
ters: Each one of the nine menus contains the functions for a certain topic:
− PAR: Control parameters
− IN: Input
− SETP: Set point
− CNTR: Controller
− OUT: Output
− ALRM: Limit relays
− AUX: Additional functions
− TUNE: Start-up adaptation
− I-O: Process data